Models F9304, F93C4

Wire rope force transducer

With integrated amplifier up to 30 t

Selected documents
Sales contact Questions? Find a contact in your vicinity.


  • Overload protection
  • Measurement of rope tension

Special features

  • Measuring ranges 0 ... 1 t to 0 ... 30 t
  • Relative linearity error up to ≤ ±1.0 % Fnom
  • Wire rope diameter 8 ... 44 mm, suitable for retrofitting
  • Material: Stainless steel, IP67
  • Optional: Redundant output signal, ATEX version


The wire rope force transducer with integrated amplifier is designed for measuring ranges up to 30 t and wire rope diameters of 8 ... 44 mm. An Ex version is also available.

For the retrofitting of overload protection in existing hoist or crane systems, this force transducer is the first choice. Design changes to the machinery and also static calculations are therefore not needed.

The task of this wire rope force transducer is to monitor rope forces - robustly and precisely. The prerequisite for this is a rope anchor point, as the measurement takes place on the stationary rope. For this purpose, the transducer is clamped with a few simple steps onto the rope, once it is fully installed.

Overload electronics as a system solution are also possible.

Wish list - Documents (0)

There are currently no documents on your wish list. You can add any document from the download area to your wish list. To do this, select the desired language using the flag symbol.

The maximum number of 20 entries was reached.

To receive your download link via e-mail, enter your address here:

The e-mail address is invalid.